LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Intrepid ES, 3.5 V >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Air Bag Restraint Systems) >> Diagnostic Tests >> Test 4A: Seat Squib Circuit Open

Test 4A: Seat Squib Circuit Open

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE  under DIAGNOSTICS. Perform TEST VER-1: AIR BAG VERIFICATION TEST  after all repairs unless otherwise directed.
  1. Turn ignition switch to ON position. Using DRBIII, determine if SEAT SQUIB CIRCUIT OPEN is active or stored Diagnostic Trouble Code (DTC). If left or right Side Impact Air Bag Control Module (SIACM) is generating an active DTC, go to next step. If left or right SIACM is generating a stored DTC, go to TEST 1B: REPAIRING STORED CODES  .
  2. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Access appropriate side air bag and disconnect harness connector. See SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect appropriate SRS load tool to side air bag harness connector. Turn ignition switch to ON position. Connect negative battery cable. Using DRBIII, read SIACM DTCs. If DRBIII displays SEAT SQUIB CIRCUIT OPEN, go to next step. If DRBIII does not display SEAT SQUIB CIRCUIT OPEN, replace faulty side air bag module.
  3. Turn ignition switch to OFF position. Disconnect negative battery cable and wait at least 2 minutes. Access appropriate SIACM and disconnect harness connector. See SIDE IMPACT AIR BAG CONTROL MODULE (SIACM)  under REMOVAL & INSTALLATION. Connect appropriate SRS load tool adaptor to SIACM harness connector. Measure resistance in appropriate side air bag line 1 circuit between load tool adaptor and side air bag harness connector. See WIRING DIAGRAMS  . Measure resistance in appropriate side air bag line 2 circuit between load tool adaptor and side air bag harness connector. If resistance is less than one ohm in both circuits, replace appropriate SIACM. If resistance is more than one ohm in either circuit, repair open in appropriate circuit.
scientia non olet · About LEMON Manuals