Test 25A: Air Bag Warning Light Circuit Open, Air Bag Warning Light Circuit Short
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE
under DIAGNOSTICS. Perform TEST VER-1: AIR BAG VERIFICATION TEST
after all repairs unless otherwise directed.
- Turn ignition switch to ON position. Using DRBIII, determine if AIR BAG WARNING LIGHT CIRCUIT OPEN or AIR BAG WARNING LIGHT CIRCUIT SHORT is active or stored Diagnostic Trouble Code (DTC). If AIR BAG WARNING LIGHT CIRCUIT OPEN or AIR BAG WARNING LIGHT CIRCUIT SHORT is an active DTC, go to next step. If AIR BAG WARNING LIGHT CIRCUIT OPEN or AIR BAG WARNING LIGHT CIRCUIT SHORT is a stored DTC, go to TEST 1B: REPAIRING STORED CODES .
- Using DRBIII, ensure instrument cluster is communicating on the PCI bus. If DRBIII shows instrument cluster is communicating on the PCI bus, go to next step. If DRBIII does not show instrument cluster is communicating on the PCI bus, diagnose malfunction in instrument cluster and/or instrument cluster bus circuit.
- On DRBIII, select PASSIVE RESTRAINTS, AIRBAG, MONITOR DISPLAY. View WARNING LIGHT MONITOR and select LIGHT STATUS. If DRBIII displays LIGHT STATUS: OK, and no other malfunctions are detected, replace Occupant Restraint Controller (ORC). See OCCUPANT RESTRAINT CONTROLLER (ORC) under REMOVAL & INSTALLATION. If DRBIII does not display LIGHT STATUS: OK, replace instrument cluster . See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION.