LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2003 >> Intrepid ES, 3.5 V >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Air Bag Restraint Systems) >> Diagnostic Tests >> Test 19A: No Right SIACM Message

Test 19A: No Right SIACM Message

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE  under DIAGNOSTICS. Perform TEST VER-1: AIR BAG VERIFICATION TEST  after all repairs unless otherwise directed.
  1. Turn ignition switch to ON position. Using DRBIII, determine if right Side Impact Air Bag Control Module (SIACM) status message an active or stored Diagnostic Trouble Code (DTC). If right SIACM status message is an active DTC, go to next step. If right SIACM status message is a stored DTC, go to TEST 1B: REPAIRING STORED CODES  .
  2. On DRBIII, select PASSIVE RESTRAINTS, SIDE AIRBAG and then RIGHT SIDE AIRBAG. If DRBIII displays NO RESPONSE or BUS +/- SIGNAL OPEN, go to VEHICLE COMMUNICATIONS  and diagnose corresponding symptom. If DRBIII does not display NO RESPONSE or BUS +/- SIGNAL OPEN, and no other malfunctions are detected, replace Occupant Restraint Controller (ORC). See OCCUPANT RESTRAINT CONTROLLER (ORC)  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals