Test 16A: No Cluster Message
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE
under DIAGNOSTICS. Perform TEST VER-1: AIR BAG VERIFICATION TEST
after all repairs unless otherwise directed.
- Turn ignition switch to ON position. Using DRBIII, determine if MIC message from instrument cluster is an active or stored Diagnostic Trouble Code (DTC). If MIC message is an active DTC, go to next step. If MIC message is a stored DTC, go to TEST 1B: REPAIRING STORED CODES .
- Using DRBIII, ensure instrument cluster communicating on the PCI bus. If instrument cluster is communicating on the PCI bus, replace Occupant Restraint Controller (ORC). See OCCUPANT RESTRAINT CONTROLLER (ORC) under REMOVAL & INSTALLATION. If instrument cluster is not communicating on the PCI bus, diagnose instrument cluster bus circuit malfunction.