Preliminary Inspection

WARNING: This page is about a different variant/trim than selected.

Transaxle malfunctions may be caused by improper fluid or fluid level, poor engine performance, improper adjustments, or failure of hydraulic, mechanical or electronic components. Always begin by checking fluid level and fluid condition. Perform road test to determine if problem has been corrected. See ROAD TEST under PERFORMANCE TESTS. If problem still exists, diagnose by symptom. See SYMPTOM DIAGNOSIS .

Prior to diagnosing the transaxle electronic control system, ensure throttle and shift cables are properly adjusted and fluid level is correct. Ensure engine starts with gearshift lever in Park and Neutral to ensure proper adjustment of park/neutral position switch. Ensure all system-related fuses are okay. Check wiring harness for proper routing. Verify all harness and component connections are clean and tight. See WIRING DIAGRAMS . Repair as necessary. If area of fault can not be located or repaired during preliminary inspection, check self-diagnostic system. See SELF-DIAGNOSTIC SYSTEM .