LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (2.4L DOHC Engine) >> Overhaul >> Cylinder Block Assembly >> Cylinder Block

Cylinder Block

WARNING: This page is about a different variant/trim than selected.

Measure cylinder bore .394" (10.0 mm) below top of cylinder bore, at middle of bore and .394" (10.0 mm) from bottom of cylinder bore. Check cylinder block deck surface warpage. Resurface cylinder block if warpage exceeds specification. See CYLINDER BLOCK  table under ENGINE SPECIFICATIONS. DO NOT grind more than .008" (.20 mm) total from surface of cylinder head and deck surface of cylinder block.

scientia non olet · About LEMON Manuals