LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Anti-Lock Brake System (Except Coupe)) >> Rear Wheel Speed Sensor >> Removal >> Removal - Sedan Jr41

Removal - Sedan Jr41

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fold down rear seat back.
  2. Disconnect speed sensor connector at vehicle wiring harness found at lower outside corner of seat back.
  3. Raise vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE) .
  4. Remove rear tire and wheel assembly from vehicle.
  5. Remove speed sensor harness sealing grommet retainer from the rear frame rail of the vehicle. See Figure.
  6. Remove speed sensor harness sealing grommet and harness from hole in body of vehicle.
  7. Remove speed sensor routing clips from the rear upper control arm.
  8. Remove bolt, then wheel speed sensor from vehicle. See Figure.
scientia non olet · About LEMON Manuals