Removal - Convertible Jr27

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Remove rear seat cushion and back. (Refer to BODY/SEATS/REAR SEAT BACK - REMOVAL)

Roll back the main silencer pad along the side to expose the wheel speed sensor harness connector located behind the wheel house silencer. See Fig 1.

Fig 1: Speed Sensor Harness Connector Location

Courtesy of DAIMLERCHRYSLER CORP.

1 - MAIN SILENCER PAD

2 - WHEEL HOUSE SILENCER

3 - SEAT BELT

4 - SENSOR HARNESS CONNECTOR

Pull the wheel speed sensor harness connector out from behind the wheel house silencer. It should have a foam sleeve covering it. See Fig 2.

Fig 2: Foam Sleeve Covered Sensor Harness Connector

Courtesy of DAIMLERCHRYSLER CORP.

1 - WHEEL HOUSE SILENCER

2 - SEAT BELT

3 - FOAM SLEEVE COVERED CONNECTOR

Push foam sleeve up off connector and disconnect speed sensor harness connector from vehicle wiring harness. See Fig 3.

Fig 3: Sensor Harness Connector
Courtesy of DAIMLERCHRYSLER CORP.

1 - FOAM SLEEVE

2 - SEAT BELT

3 - CONNECTOR
Raise vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE) .

Remove speed sensor harness sealing grommet retainer from the rear frame rail of the vehicle. See Fig 4.

Fig 4: Rear Speed Senor Cable Attachment To Body

Courtesy of DAIMLERCHRYSLER CORP.

1 - SEALING GROMMET RETAINER

2 - BRAKE FLEX HOSE

3 - SPEED SENSOR CABLE

4 - SEALING GROMMET

5 - BOLT

6 - REAR INNER FENDER

Remove speed sensor harness sealing grommet and harness from hole in body of vehicle.
Remove speed sensor routing clips from the rear upper control arm.
Remove bolt, then wheel speed sensor from vehicle. See Fig 5.

Fig 5: Rear Speed Sensor Head Attachment To Brake Support Plate

Courtesy of DAIMLERCHRYSLER CORP.

1 - SPEED SENSOR CABLE

2 - BOLT

3 - SPEED SENSOR HEAD