LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Emission Control System - Except Coupe) >> Air Injection >> Mass Air Flow Sensor >> Installation

Mass Air Flow Sensor: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rubber mounting to MAF sensor.
  2. Twist the MAF sideways and install to bracket. See Figure.
    Fig 1: Removing/Installing Sensor From Bracket
    GC0031945Courtesy of DAIMLERCHRYSLER CORP.
  3. Connect the electrical connector to MAF.
    Fig 2: Mass Air Flow Sensor
    GC0031944Courtesy of DAIMLERCHRYSLER CORP.
  4. Install the bracket assembly. See Figure.
    Fig 3: Remove/Install Assembly
    GC0031943Courtesy of DAIMLERCHRYSLER CORP.
  5. Install 2 bracket mounting bolts. See Figure.
    Fig 4: Mounting Bracket Bolts
    GC0031941Courtesy of DAIMLERCHRYSLER CORP.
  6. Install the air pump assembly, (Refer to EMISSIONS CONTROL/AIR INJECTION/PUMP - INSTALLATION) .
  7. Connect negative battery cable.
scientia non olet · About LEMON Manuals