LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Ignition Control - Except Coupe) >> Knock Sensor >> Installation >> Installation - 2.7L

Installation - 2.7L

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

The sensors screws into the cylinder block, directly below the intake manifold.

  1. Install knock sensor. See Figure. Tighten knock sensor to 10 N.m (7 ft. lbs.) torque. Over or under tightening effects knock sensor performance resulting in possible improper spark control. 
  2. Install the passenger side cylinder head, refer to INSTALLATION .
  3. Attach electrical connector to knock sensor.
  4. Install intake manifold plenum. Refer to INSTALLATION .
scientia non olet · About LEMON Manuals