LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Sunroof >> Sunroof Drive Motor >> Removal

Sunroof Drive Motor: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The sunroof system is timed from the factory so that the motor shuts off automatically when the sunroof window reaches a certain position. Extreme care must be taken when removing the motor from the sunroof module assembly or this timing may be thrown off causing damage to the sunroof system. Anytime the motor needs to be removed from the module assembly the sunroof window must be in the FULLY CLOSED POSITION if possible.

If glass panel is not in the fully closed position and the motor is removed or inoperative, (Refer to BODY/SUNROOF/DRIVE MOTOR - ADJUSTMENTS) 

  1. Remove A-pillar trim (Refer to BODY/INTERIOR/A-PILLAR TRIM - REMOVAL) 
  2. Remove sun visors (Refer to BODY/INTERIOR/SUN VISOR - REMOVAL) 
  3. Remove map lamps/mini console
  4. Disconnect the control switch wire connector.
  5. Remove sunroof opening trim lace. (Refer to BODY/SUNROOF/OPENING TRIM LACE - REMOVAL) .
  6. Remove headliner as necessary to gain access to sunroof drive motor. (Refer to BODY/INTERIOR/HEADLINER - REMOVAL) .
  7. Disconnect the drive motor wire harness connectors.
  8. Remove drive motor attaching screws.
  9. Remove motor from the sunroof housing
scientia non olet · About LEMON Manuals