LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Hood >> Latch Release Cable >> Installation

Latch Release Cable: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route hood release cable through hole in lower dash panel and along inner frame rail.
  2. Engage rubber grommet to lower dash panel.
  3. Engage push-in fastener attaching hood release cable to lower dash panel.
  4. Install screws attaching hood release cable handle to inner cowl panel.
  5. Tighten screws to 1.8 N.m (16 in. lbs.) torque.
  6. Install left front cowl trim panel.
  7. Engage hood release cable into clips along inner frame rail. See Figure.
  8. Install hood latch (Refer to BODY/HOOD/LATCH - INSTALLATION) .
scientia non olet · About LEMON Manuals