Top Of Glass - Inboard/Outboard Adjustments
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Remove quarter trim panel. (Refer to BODY/INTERIOR/QUARTER PANEL TRIM - REMOVAL) NOTE: Alternatively, the lower adjustment can be accessed through a hole at the bottom of the quarter trim panel. This hole can be located by removing the rear seat cushion. (Refer to BODY/SEATS/SEAT CUSHION - REMOVAL)
- Remove center and rear side rail weatherstrips from side rail weatherstrip retainer channels.
- Using a suitable wrench, loosen the lower jack screw jam nuts.
- Raise quarter glass.
- Using a suitable Allen wrench, rotate jackscrews to achieve the proper gap between the door glass weatherstrip retainer channel. See Figure.
- Verify that the quarter glass maintains even contact with the outer belt weatherstrip.
- Install center and rear side rail weatherstrips to side rail weatherstrip retainer channels.
- Cycle quarter glass between full up and full down positions. Verify operation and adjust as necessary.
- Tighten all fasteners.
- Verify that the top edge of the door glass is beneath the lip of the weatherstrip with glass in the full up position.
- Install quarter trim panel. (Refer to BODY/INTERIOR/QUARTER PANEL TRIM - INSTALLATION)