LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Suspension System - Except Coupe) >> Rear Suspension >> Hub / Bearing >> Removal

Hub / Bearing: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE) .
  2. Remove rear wheel and tire assembly.
  3. If equipped with rear disc brakes, remove the rear brake caliper and rotor. (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTORS - REMOVAL) . Remove the brake rotor by pulling the rotor straight off the wheel mounting studs.
  4. If equipped with rear drum brakes, remove the brake drum. (Refer to BRAKES/HYDRAULIC/MECHANICAL/DRUM - REMOVAL)
  5. Remove dust cap from rear hub and bearing assembly by prying it off.
  6. Remove hub and bearing retaining nut.
  7. Remove rear hub and bearing from the spindle by pulling it straight off the spindle.
scientia non olet · About LEMON Manuals