LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Air Bag Restraint Systems - Except Coupe) >> Satellite Acceleration Sensor >> Removal

Satellite Acceleration Sensor: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable remote terminal.
  2. Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
  3. Remove the lower B-pillar trim from the appropriate side of the vehicle. Refer to REMOVAL .
  4. Disconnect the satellite acceleration sensor (SAS) electrical connector.
  5. Remove the SAS retaining screws and remove the sensor from the vehicle.
scientia non olet · About LEMON Manuals