LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Air Bag Restraint Systems - Except Coupe) >> Front Seat Belt & Retractor - Convertible Jr27 Only >> Installation

Front Seat Belt & Retractor - Convertible Jr27 Only: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Inspect the condition of the shoulder and lap belt. Replace any belt that is cut, frayed, torn, or damaged in any way. Also, replace the shoulder belt if the retractor is either damaged or inoperative.

  1. Position seat belt retractor to seat frame.
  2. Connect wire connector to seat belt retractor.
  3. Install new bolts to hold seat belt retractor to seat frame. Tighten the retractor bolts to 16.2 N.m (12 ft. lbs.) torque.
  4. Install seat belt retractor cover.
  5. Install seat cover. Refer to INSTALLATION .
  6. Attach lower seat belt anchor to bolt on seat adjuster.
  7. Verify that seat belt is routed such that it will not be twisted when engaged to the seat belt buckle.
  8. Verify that a minimum of three threads extend beyond the lower seat belt anchor nut and that the lower seat belt anchor swivels freely. If both conditions are not found, check that the bolt is fully engaged to the seat adjuster.
  9. Install seat in vehicle. Refer to INSTALLATION .
    CAUTION: Failure to follow proper installation procedure may result in the seat track latch pins not being synchronized.
  10. Connect the battery negative cable.
scientia non olet · About LEMON Manuals