Driver Airbag: Removal
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
- Remove speed control switch screws from steering wheel back cover, remove switches and disconnect the wires.
- Remove two bolts retaining Driver Airbag.
- Lift airbag and disconnect the two airbag initiators, and horn switch wire connectors.
- Remove Driver Airbag from vehicle.
WARNING:
WHEN REPLACING A DEPLOYED DRIVER AIRBAG, THE CLOCK SPRING MUST ALSO BE REPLACED. REFER TO REMOVAL AND INSTALLATION . FAILURE TO DO SO COULD RESULT IN OCCUPANT PERSONAL INJURY OR DEATH.