LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Air Bag Restraint Systems - Except Coupe) >> Driver Airbag Trim Cover >> Removal

Driver Airbag Trim Cover: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

The horn switch is integral to the driver airbag trim cover. If the horn switch is faulty or the driver airbag cover is scratched or distorted, the driver airbag trim cover and horn switch unit must be replaced.

  1. Disconnect and isolate the battery negative remote cable.
  2. Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
  3. Remove the driver airbag. Refer to REMOVAL .
  4. Disconnect the horn switch ground wire (black) connector from the airbag mounting plate tab.
  5. Disconnect the horn switch feed wire (red) connector from the airbag mounting plate tab.
  6. Remove the four hex nuts that secure the airbag mounting plate to the airbag.
  7. Remove the airbag mounting plate form the airbag.
  8. Remove the airbag trim cover from the airbag inflator adaptor by rotating the trim cover mounting flaps off of the mounting studs and disengaging the three tab and slot details.
NOTE: The folded cushion will remain intact by the bag wrap. Do not remove the bag wrap when servicing the airbag trim cover.
scientia non olet · About LEMON Manuals