LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Air Bag Restraint Systems - Except Coupe) >> Child Restraint Anchor >> Installation

Child Restraint Anchor: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: During, and following, any child restraint anchor service, due to impact event or vehicle repair, carefully inspect all mounting hardware, tether straps and anchors for proper installation, operation, or damage. If a child restraint anchor is found damaged in any way, the anchor must be replaced. Failure to do so could result in occupant personal injury or death.
  1. Place LATCH bracket on studs and install retaining nuts. Torque nuts to 40 N.m (350 in. lbs.).
  2. Install the rear seat cushion (Refer to BODY/SEATS/SEAT CUSHION - INSTALLATION) .
scientia non olet · About LEMON Manuals