LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Interior & Exterior - Except Coupe) >> Seats >> Front Seat Cushion >> Installation - Front

Installation - Front

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install wire harness fasteners to cushion frame.
  2. Install seat cushion bolts.
  3. Install seat back. Tighten recliner bolts to 12 N.m (9 ft. lbs.) torque. Tighten pivot bolts to 40 N.m (30 ft. lbs.) torque.
  4. Connect switch wire connectors to the cushion side shield, if equipped.
  5. Install cushion side shields.
  6. Install seat in vehicle.
scientia non olet · About LEMON Manuals