LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Exhaust Manifold >> Installation >> Rear Exhaust Manifold

Rear Exhaust Manifold

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install exhaust manifold and gasket. Tighten bolts working from center outwards to 23 N.m (200 in. lbs.).
  2. Install rear catalytic converter and manifold heat shield. Tighten fasteners to 28 N.m (250 in. lbs.) (Refer to EXHAUST SYSTEM/CATALYTIC CONVERTER - INSTALLATION) .
  3. Install oxygen sensor and connect electrical connector.
  4. Install exhaust cross-under pipe. Tighten fasteners to 28 N.m (250 in. lbs.) (Refer to EXHAUST SYSTEM/CROSS-OVER PIPE - INSTALLATION) .
  5. Install exhaust system. Tighten fasteners to 28 N.m (250 in. lbs.) (Refer to EXHAUST SYSTEM - INSTALLATION) .
  6. Lower vehicle.
  7. Install EGR tube using new gaskets. Tighten screws to 11 N.m (95 in. lbs.).
  8. Install throttle body air inlet hose and air cleaner housing assembly.
  9. Connect negative battery cable.
scientia non olet · About LEMON Manuals