LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Exhaust System - Except Coupe) >> Cross-Under Pipe - 2.7L >> Installation

Cross-Under Pipe - 2.7L: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new gasket to lower part of rear catalytic converter. If installing new cross-under pipe, transfer oxygen sensors to new pipe. See Figure.
  2. Loosely install cross-under pipe to catalytic converters. See Figure. Snug nuts up equally using hand pressure.
  3. Tighten 2 nuts for cross-under pipe to rear catalytic converter to 28 N.m (250 in. lbs.). See Figure.
  4. Tighten 2 nuts for cross-under pipe to front catalytic converter to 28 N.m (250 in. lbs.). See Figure.
  5. Connect exhaust system pipe to cross-under pipe. Tighten attaching fasteners to 28 N.m (250 in. lbs.)
  6. Install oil pan to transmission structural collar. (Refer to ENGINE/ENGINE BLOCK/STRUCTURAL COVER - INSTALLATION)
  7. Reconnect downstream oxygen sensor connectors.
  8. Lower vehicle.
  9. Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
  10. Check the exhaust system for contact with the body panels. Make the necessary adjustments, if needed.
scientia non olet · About LEMON Manuals