LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (2.7L DOHC Engine (Service Information) - Except Coupe) >> Exhaust Manifold >> Installation >> Front Exhaust Manifold

Front Exhaust Manifold

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install exhaust manifold and gasket. Tighten bolts starting at the center working outward to 23 N.m (200 in. lbs.).
  2. Raise vehicle on hoist.
  3. Install front catalytic converter and manifold heat shield. Tighten fasteners to 28 N.m (250 in. lbs.) (Refer to EXHAUST SYSTEM/CATALYTIC CONVERTER - INSTALLATION) .
  4. Install exhaust cross-under pipe. Tighten fasteners to 28 N.m (250 in. lbs.) (Refer to EXHAUST SYSTEM/CROSS-OVER PIPE - INSTALLATION) .
  5. Lower vehicle.
  6. Install oxygen sensor and connect electrical connector.
  7. Connect negative battery cable.
scientia non olet · About LEMON Manuals