LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (2.4L DOHC Engine (Service Information) - Except Coupe) >> Lubrication >> Diagnosis And Testing >> Checking Engine Oil Pressure

Checking Engine Oil Pressure

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and remove oil pressure switch. (Refer to ENGINE/LUBRICATION/OIL PRESSURE SENSOR/SWITCH - REMOVAL) 
  2. Install Special Tools C-3292 Gauge with 8406 Adaptor fitting.
  3. Start engine and record oil pressure. Refer to Specifications for correct oil pressure requirements. (Refer to ENGINE - SPECIFICATIONS) 
    CAUTION: If oil pressure is 0 at idle, do not perform the 3000 RPM test
  4. If oil pressure is 0 at idle. Shut off engine, check for pressure relief valve stuck open, a clogged oil pick-up screen or a damaged oil pick-up tube O-ring.
  5. After test is complete, remove test gauge and fitting.
  6. Install oil pressure switch and connector. (Refer to ENGINE/LUBRICATION/OIL PRESSURE SENSOR/SWITCH - INSTALLATION) 
scientia non olet · About LEMON Manuals