LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (2.4L DOHC Engine (Service Information) - Except Coupe) >> Oil Pressure Sensor/Switch >> Installation

Oil Pressure Sensor/Switch: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install oil pressure switch and connect electrical connector. See Figure.
  2. Lower vehicle.
  3. Start engine and allow to run a minimum of 2 minutes.
  4. Shut engine off and check engine oil level. Adjust level as necessary.
scientia non olet · About LEMON Manuals