LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (2.4L DOHC Engine (Service Information) - Except Coupe) >> Hydraulic Lash Adjusters >> Removal

Hydraulic Lash Adjusters: Removal

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure is for in-vehicle service with camshafts installed.
  1. Remove cylinder head cover. (Refer to ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S)  - REMOVAL)
  2. Remove rocker arm. (Refer to ENGINE/CYLINDER HEAD/ROCKER ARMS - REMOVAL) 
  3. Remove hydraulic lash adjuster. See Fig 1.
  4. Repeat removal procedure for each hydraulic lash adjuster.
  5. If reusing, mark each hydraulic lash adjuster for reassembly in original position. Lash adjusters are serviced as an assembly.
Fig 1: Hydraulic Lash Adjuster
GC0021202Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals