LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (2.0L DOHC Engine (Service Information) - Except Coupe) >> Valve Springs And Seals >> Removal >> Cylinder Head On

Cylinder Head On

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable.
  2. Remove timing belt (Refer to ENGINE/VALVE TIMING/TIMING BELT/CHAIN AND SPROCKETS - REMOVAL) .
  3. Remove cylinder head cover (Refer to ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S)  - REMOVAL).
  4. Remove camshafts (Refer to ENGINE/CYLINDER HEAD/CAMSHAFT(S)  - REMOVAL).
  5. Rotate crankshaft until piston is at TDC.
  6. With air hose attached to adapter tool installed in spark plug hole, apply 90-120 psi air pressure.
  7. Using Special Tool MD-998772-A with adapter 6779, compress valve springs and remove valve locks. See Fig 1.
  8. Remove valve spring(s).
  9. Remove valve stem seal(s) by a using valve stem seal tool. See Figure.
Fig 1: Valve Spring - Removal/Installation
GC0032041Courtesy of DAIMLERCHRYSLER CORP.
1 - VALVE SPRING COMPRESSOR MD 998772A
2 - AIR HOSE
scientia non olet · About LEMON Manuals