LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Diagnosis - Automatic Transmission - Coupe) >> Automatic Transaxle Diagnosis >> Line Pressure Adjustment

Line Pressure Adjustment

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the transmission fluid.
    NOTE: The hydraulic pressure test must be performed before attempting any adjustments.
  2. Remove the valve body cover.
  3. Turn the adjusting screw shown in the illustration to adjust the line pressure to the standard value. The pressure increases when the screw is turned counterclockwise.
    NOTE: When adjusting the line pressure, adjust to the middle of the standard value range.

    Standard value: 1.01 - 1.05 MPa (147 - 152 psi) 

  4. Install the valve body cover. Pour in one quart transmission fluid.
  5. Repeat the hydraulic pressure test. (Refer to TORQUE CONVERTER STALL TEST JUDGEMENT RESULTS  ). Readjust the line pressure if necessary.
    Fig 1: Locating Adjusting Screw
    G04541773Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals