LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Mechanical Brake System - Base (Service Information) - Coupe) >> On-Vehicle Service >> Brake Pedal Check And Adjustment >> Brake Pedal Height

Brake Pedal Height

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn up the carpet etc. under the brake pedal.
  2. Measure the brake pedal height as illustrated. If it is not within the standard value, adjust as follows.

    Standard value: 175 - 178 mm (6.9 - 7.0 inches) [From the surface of melting sheet (floorboard) to the face of pedal pad] 

    1. Disconnect the stoplight switch connector.
    2. Rotate the stoplight switch 1/4 turn counter clockwise to loosen.
      Fig 1: Measuring Brake Pedal Height
      G04537065Courtesy of DAIMLERCHRYSLER CORPORATION
    3. Loosen the operating rod jam nut. Turn the serrations of the operation rod with pliers to adjust the brake pedal height to the standard valve.
      Fig 2: Loosening Operating Rod Jam Nut
      G04537066Courtesy of DAIMLERCHRYSLER CORPORATION
    4. Turn the stoplight switch until it's thread part contacts the stopper. During this step, secure the pedal by moving it forward by hand.
    5. Turn the stoplight switch 1/4 turn clockwise to secure. Then confirm that the clearance between the switch plunger and the stopper is as shown.
    6. Connect the connector of the stoplight switch.
    7. Check to be sure that the stoplight does not illuminated with the brake pedal released
  3. Return the carpet, etc. to its original position.
    Fig 3: Checking Clearance Between Switch Plunger And Stopper
    G04537067Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals