Brake Lining Thickness Check
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Whenever the shoe and lining assembly is replaced, replace both RH and LH assemblies as a set to prevent the car from pulling to one side when braking.
- If there is a significant difference in the thickness of the shoe and lining assemblies on the left and right sides, check the sliding condition of the piston.
NOTE:
For brake lining thickness for drum-in-disc brake, refer to
PARKING BRAKE DRUM
.
- Remove the brake drum.
- Measure the thickness of the brake lining at the area with the worst wear.
Standard value: 4.9 mm (0.19 inch)
Minimum limit: 1.0 mm (0.04 inch)
- Replace the shoe and lining assembly if the brake lining thickness is less than the limit or if it is not worn evenly. For installation procedures for the shoe and lining assembly, refer to REAR DRUM BRAKE .