LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Mechanical Brake System - Base (Service Information) - Coupe) >> On-Vehicle Service >> Brake Disc Thickness Check >> < Rear >

< Rear >

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove dirt and rust from the brake disc surface.
  2. Measure the disc thickness at four positions or more.

    Standard value: 10.0 mm (0.4 inch) 

    Minimum limit: 8.4 mm (0.33 inch) 

  3. Thickness variations (at least 4 positions) should not be more than 0.015 mm (0.0006 inch).
  4. If the disc is thickness than 8.4 mm (0.33 inch) thick, replace it with a new one. If thickness variation exceeds the specification, turn rotor with an on-the-car brake lathe ("Accuturn-8750" or equivalent).

    If the calculated final thickness is less than the standard value, replace the disc.

    Fig 1: Measuring Disc Thickness (Rear)
    G04537095Courtesy of DAIMLERCHRYSLER CORPORATION
scientia non olet · About LEMON Manuals