LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Power Door Locks - Except Coupe) >> Remote Keyless Entry Module >> Installation

Remote Keyless Entry Module: Installation

WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Snap the remote keyless entry module onto the BCM.
  2. Connect BCM to the Junction Block.
  3. Connect the BCM and junction block together.
  4. Install the Junction Block/BCM into vehicle.
  5. Connect BCM wire connectors and install the assembly onto instrument panel.
  6. Install the Junction Block/BCM by pushing straight up.
  7. Install the Junction Block three mounting screws.
  8. Install the wire harness connectors to the Junction Block.
  9. Install the silencer.
  10. Install the left lower instrument panel trim.
  11. Install the instrument panel inboard bezel (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TRIM - INSTALLATION) .
  12. Install the instrument panel center bezel (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL CENTER BEZEL - INSTALLATION) .
  13. Install the instrument panel outboard bezel (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TRIM - INSTALLATION) .
  14. Install the left end cover.
  15. Connect the remote battery negative cable to the remote terminal on the shock tower.
scientia non olet · About LEMON Manuals