LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.7L V6 Engine - VIN U >> Valve Timing >> Timing Belt/Chain Cover(S) >> Removal & Installation >> Installation

Removal & Installation: Installation

  1. Inspect and clean timing chain cover sealing surfaces.
  2. Before installing timing cover gasket apply a 1/8 inch bead of Mopar® Engine RTV GEN II to the parting lines between the oil pan and cylinder block.
    Fig 1: Applying Seal To Timing Chain Cover
    G00387246Courtesy of CHRYSLER CORP.
  3. Install timing cover and gasket. Tighten M10 cover bolts to 54 N.m (40 ft. lbs) and M6 bolts to 12 N.m (105 INCH lbs). See Figure.
  4. Install front crankshaft oil seal using Special Tool 6780-2 sleeve and 6780-1 installer.
  5. Lower vehicle.
  6. Install right engine mount. See INSTALLATION .
  7. Install screws attaching heater supply tube to right front frame rail area.
  8. Raise vehicle on hoist.
  9. Connect heater hose to supply tube at right front frame rail area.
  10. Install AC/Generator belt tensioner/bracket assembly.
  11. Install crankshaft vibration damper.
  12. Install accessory drive belts.
  13. Install belt splash shield and right front wheel.
  14. Lower vehicle.
  15. Install coolant pressure container.
  16. Fill cooling system.
  17. Connect negative battery cable.
scientia non olet · About LEMON Manuals