LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.7L V6 Engine - VIN U >> Cylinder Head >> Cylinder Head Cover - Left >> Removal & Installation >> Removal

Removal & Installation: Removal

  1. Disconnect negative battery cable.
  2. Remove upper intake manifold. See REMOVAL - UPPER INTAKE MANIFOLD .
  3. Disconnect electrical connectors from ignition coils and capacitor. Reposition electrical harness.
  4. Remove ground strap from cylinder head cover stud.
  5. Disconnect electrical harness retaining clips from cylinder head cover studs. Reposition electrical harness.
  6. Remove fastener attaching ignition coil capacitor.
  7. Loosen all cylinder head cover fasteners.
    NOTE: Cylinder head cover attaching bolts are captured to the cover.
    CAUTION: Make certain the double ended studs in the center of the cylinder head cover are loose before attempting to remove cover.
    Fig 1: Loosening Cylinder Head Cover
    G00378528Courtesy of CHRYSLER CORP.
  8. Remove cylinder head cover.
scientia non olet · About LEMON Manuals