LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System - TEVES Mark 20 - Except Coupe >> Bleeding Brake System >> Pressure Bleeding

Pressure Bleeding

  1. Connect pressure bleeder to master cylinder using appropriate adapters. Remove rubber duct caps from all 4 bleeder valves. Install clear hose on left rear bleed valve. Place other end of hose in clean transparent container of clean brake fluid. Ensure that the end of clear hose is submerged in brake fluid.
  2. Open the valve on the pressure bleeder assembly. Open the bleed valve at least one full turn. Close the bleed valve when brake fluid flow is clear and free of bubbles.
  3. Bleed remaining brakelines in proper sequence at each wheel. See BRAKELINE BLEEDING SEQUENCE  table. Install rubber duct caps on all 4 bleeder valves. Close valve on pressure bleeder. Remove pressure bleeder from master cylinder. Fill master cylinder with brake fluid (if necessary). Install cap on master cylinder.
scientia non olet · About LEMON Manuals