LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System - TEVES Mark 20 - Except Coupe >> Bleeding Brake System >> Manual Bleeding

Manual Bleeding

  1. Fill master cylinder (if necessary). Reinstall master cylinder cap. Remove rubber duct caps from all 4 bleeder valves. Install clear hose on left rear bleed valve. Place other end of hose in clean transparent container of clean brake fluid. Ensure that the end of clear hose is submerged in brake fluid.
  2. Pump brake pedal 3-4 times. Hold brake pedal down. Open bleed valve at least one full turn. Brake pedal should drop to floor. Close bleed valve. Release brake pedal. Repeat bleeding procedure until brake fluid flow is clear and free of bubbles. Bleed remaining brakelines in proper sequence at each wheel. See BRAKELINE BLEEDING SEQUENCE  table. Install rubber duct caps on all 4 bleeder valves.
BRAKELINE BLEEDING SEQUENCE

Application Sequence
All Models LR, RF, RR, LF
scientia non olet · About LEMON Manuals