LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.7L V6 Engine - VIN U >> Lubrication >> Oil Pump >> Removal & Installation >> Installation

Removal & Installation: Installation

CAUTION: Crankshaft position must be at 60° ATDC of No. 1 cylinder before installing oil pump. This position will properly locate oil pump. If not properly located, severe damage to oil pump can occur. See Figure.
  1. Prime oil pump before installation by filling rotor cavity with engine oil.
  2. If crankshaft has been rotated, it must be repositioned to 60° ATDC of No. 1 cylinder prior to oil pump installation. See Figure.
  3. Install oil pump carefully over crankshaft and into position.
  4. Install oil pump attaching bolts. Tighten bolts to 28 N.m (250 INCH lbs). See Figure.
  5. Install oil pick-up tube with new O-ring. Lubricate O-ring before installation. Tighten attaching bolts to 28 N.m (250 INCH lbs). See Figure.
  6. Install oil pan. See INSTALLATION .
  7. Install timing chain and sprockets. See INSTALLATION - TIMING CHAIN .
  8. Install timing chain cover. INSTALLATION .
  9. Install crankshaft vibration damper.
  10. Fill crankcase with engine oil to correct level.
scientia non olet · About LEMON Manuals