LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Diagnostic Tests >> Test 1B: Repairing Stored DTCS

Test 1B: Repairing Stored DTCS

NOTE: Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE  under DIAGNOSTICS. Perform TEST VER-1: AIR BAG VERIFICATION TEST  after all repairs unless otherwise directed.
  1. Ensure battery is fully charged and active DTCs have been resolved. Turn ignition switch to ON position. Using DRB, erase stored DTCs, then use DRB to monitor active DTCs.
  2. Wiggle SRS wiring harness and connectors. Rotate steering wheel from stop-to-stop. Visually inspect related wiring electrical connectors looking for broken, bent, pushed-out, spread, corroded, or contaminated terminals. Inspect harness for chafed, pierced, pinched or partially broken wires. If DTC became active, go to appropriate test. If DTC did not become active, erase all DTCs.
scientia non olet · About LEMON Manuals