LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1996 >> Sebring LXi >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.5L V6 Engine - VIN [N] - Avenger & SEBRING Coupe >> Removal & Installation >> On Vehicle Hydraulic Lash Adjusters Bleeding

On Vehicle Hydraulic Lash Adjusters Bleeding

NOTE: If vehicle was parked on a slope or was non operational for a long period of time, air may enter hydraulic lash adjusters. Engine will be noisy during start up depending upon how much air has entered hydraulic lash adjusters.

If hydraulic lash adjusters are noisy, start engine. Gradually increase engine speed from idle to 3000 RPM within 30 seconds and decrease engine speed back to idle within 30 second. Perform this operation 3-9 times. If noise stops, bleeding procedure is complete. If noise does not stop, see NOISY VALVE TRAIN  under TROUBLE SHOOTING.

scientia non olet · About LEMON Manuals