LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1995 >> Sebring LXi >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Diagnosis - 41TE & 41AE Automatic Transmission >> Diagnostic Tests >> Test 51C - AUTOSTICK Sensor Circuit

Test 51C - AUTOSTICK Sensor Circuit

NOTE: Perform TEST 51A  before proceeding with this test. For connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagrams, see WIRING DIAGRAMS  . Perform VERIFICATION TEST VER-1A  after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
  1. Disconnect autostick switch connector at base of lever. Use scan tool in voltmeter mode. Measure voltage at terminal No. 3 on switch harness connector. If voltage is more than 10 volts, replace autostick switch. If voltage is 10 volts or less, go to next step.
  2. Disconnect Transmission Control Module (TCM) connector. Use scan tool in ohmmeter mode. Measure resistance at terminal No. 3 on switch harness connector. If resistance is less than 5 ohms, repair downshift circuit for short to ground. If resistance is 5 ohms or greater, replace TCM.
scientia non olet · About LEMON Manuals