LeBaron Convertible/Coupe
- Remove turn signal switch from under headlight switch, in instrument panel switch pod. See TURN SIGNAL SWITCH R & I under REMOVAL & INSTALLATION. White 7-pin connector next to turn signal switch 14-pin connector must remain connected when checking switch continuity. See Fig 1 .
- Using an ohmmeter, check continuity between 14-pin connector terminals. Refer to TURN SIGNAL SWITCH CONTINUITY . See Fig 1 . Replace turn signal switch if continuity is not as specified.
- If switch continuity is good, check for faulty flasher unit, related relays and/or wiring. Both hazard flasher and turn signal flasher are combined into one Yellow combo-flasher unit. This combo-flasher unit is located under instrument panel to right of steering column, mounted on A/C duct.
- Turn signal circuit uses 4 relays. Relays are identical and can be interchanged for circuit testing purposes. Relays are located in relay module, under left side of instrument panel. For wiring circuit testing, see WIRING DIAGRAMS .
TURN SIGNAL SWITCH CONTINUITY
| Switch Position | Terminals No. |
|---|---|
| Left Turn | 2 & 7, 2 & 13 |
| Right Turn | 1 & 7, 1 & 13 |