LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1992 >> Imperial >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.3L V6 - VIN [R] & 3.8L V6 - VIN [L] >> Removal & Installation >> Engine >> Installation

Removal & Installation: Engine: Installation

  1. To install, reverse removal procedure. Lubricate male end of quick connect/disconnect fuel line fittings with clean motor oil. Install fuel lines until a "click" is heard. Align engine mounts and install. DO NOT tighten mounting bolts until all mounting brackets and bolts have been installed. Check axle shaft length with damper weight removed. See Fig 1 .
    Fig 1: Measuring Axle Shaft Length
    G55249Courtesy of CHRYSLER MOTORS.
  2. Both right and left axle shaft length must be within 7.4-7.7" (188-196 mm). If axle shaft length requires adjustment, support engine/transaxle assembly with a floor jack. Loosen vertical bolts on engine mount near timing belt cover and front engine mount bracket-to-front crossmember bolts. Pry engine right or left as required to obtain correct axle shaft length.
  3. Tighten mounting bolts and nuts to specification. Recheck axle shaft length. Install damper weight (if equipped) and tighten to specification. See TORQUE SPECIFICATIONS  at end of this article. Fill cooling system.
NOTE: To fill and bleed cooling system, remove engine temperature sending unit, located in front of thermostat housing, near spark plug wire holder. Fill cooling system until coolant reaches this level. Install sending unit and tighten to 60 INCH lbs. (7 N.m). Finish filling cooling system.
scientia non olet · About LEMON Manuals