LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1992 >> Imperial >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.3L V6 - VIN [R] & 3.8L V6 - VIN [L] >> Torque Specifications

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Air Intake Plenum Bolt (1) 21 (28)
Camshaft Sprocket Bolt 40 (54)
Connecting Rod Nut
Step 1 40 (54)
Step 2 Additional 1/4 Turn
Cylinder Head Bolt (2)
Step 1 45 (61)
Step 2 65 (88)
Step 3 65 (88)
Step 4 (3) Additional 1/4 Turn
Drive Axle Shaft Damper Weight Bolt 22 (30)
EGR Tube Bolt 17 (23)
Engine Bracket Bolt 40 (54)
Engine Mount Through Bolt At Timing Belt Cover 100 (136)
Engine Mount-To-Frame At Timing Belt Cover Bolt 50 (68)
Engine Mount-To-Transaxle Through Bolt 50 (68)
Exhaust Crossover Pipe Bolt 25 (34)
Exhaust Manifold Bolt 17 (23)
Flywheel/Drive Plate Bolt 70 (95)
Fuel Rail Bolt 17 (23)
Intake Manifold Bolt (4) 21 (28)
Lower Front Mount-To-Crossmember Bolt 40 (54)
Lower Front Mount-To-Cylinder Block Bolt 40 (54)
Lower Front Mount Through Bolt 50 (68)
Main Bearing Cap Bolt
Step 1 30 (41)
Step 2 Additional 1/4 Turn
Rocker Arm Shaft Bolt 21 (28)
Timing Chain Cover 20 (27)
Torque Converter-To-Flex Plate Bolt 55 (75)
Transaxle-To-Engine Bolt 70 (95)
Vibration Damper Bolt 40 (54)
Water Pump Pulley Bolt 22 (30)
INCH Lbs. (N.m) 
Cam Sensor Retaining Bolt 105 (12)
Camshaft Thrust Plate Bolt 105 (12)
Intake Manifold Gasket Retaining Bolt 105 (12)
Oil Pan Bolt 105 (12)
Oil Pump Cover Bolt 105 (12)
Rear Crankshaft Seal Retainer Bolt 105 (12)
Valve Cover Bolt 105 (12)
Valve Lifter Yoke Retainer Bolt 105 (12)
Water Pump Bolt 105 (12)
(1) Tighten bolts in sequence. See Figure .
(2) All bolts except the No. 9 (8 mm) bolt must be tighten to specification in sequence. See Figure . The No. 9 bolt should be tightened to 25 ft. lbs. (34 N.m) after all other bolts are tightened to specification.
(3) After additional 1/4 turn, bolt torque should exceed 90 ft. lbs. (122 N.m). If not, replace bolt.
(4) Tighten bolts in sequence. See Figure .