Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Front Fender (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Front Fender Nut (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Fender Bolt (1) - Install and tighten - Fastener Specifications
Front Fender Bolt (2) - Tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Fender Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Fender Bolt (1) - Install and tighten [3x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Fender Insulator (2) - Install
Front Fender Insulator Retainer (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Position the rocker panel molding (2) to the vehicle and seat the rocker panel molding retainers (1) into the body side outer panel.
Rocker Panel Molding (2) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Side Door Below Belt Rear Auxiliary Weatherstrip (1) - Install
Ensure that the weatherstrip is fully seated.
Courtesy of GENERAL MOTORS COMPANY

Position the rear wheelhouse liner (1) to its original location.
Courtesy of GENERAL MOTORS COMPANY

Rear Tire Front Air Deflector (2) - Install
Rear Tire Front Air Deflector Bolt (1) - Install and tighten [4x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia Guide (3) - Install
Front Bumper Fascia Guide Bolt (2) - Install and tighten [2x] - Fastener Specifications
Headlamp Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Install the air inlet grille panel extension (1).
Remove the masking tape.
Using a 50/50 mixture of isopropyl alcohol and clean drinkable water with a clean towel, remove any left over adhesive residue from the masking tape.
Courtesy of GENERAL MOTORS COMPANY

Front Fender Rear Air Inlet Seal (2) - Install
Front Fender Rear Air Inlet Seal Retainer (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia (1) - Install - Front Bumper Fascia Removal and Installation
Courtesy of GENERAL MOTORS COMPANY

Position the front wheel opening molding (2) to the vehicle and seat the front wheel opening molding clips (1) into the front fender and front bumper fascia.
Front Wheel Opening Molding (2) - Install

{Left Side} Front Wheelhouse Liner - Install

Courtesy of GENERAL MOTORS COMPANY

Front Wheelhouse Liner (4) - Install

Front Wheelhouse Liner Retainer (3) - Install
Front Wheelhouse Liner Bolt (2) - Install and tighten [13x] - Fastener Specifications
Front Compartment Splash Shield Bolt (1) - Install and tighten [2x] - Fastener Specifications

{Right Side} Front Wheelhouse Liner - Install

Courtesy of GENERAL MOTORS COMPANY

Front Wheelhouse Liner (5) - Install

Front Wheelhouse Liner Retainer (4) - Install
Front Wheelhouse Liner Bolt (3) - Install and tighten [13x] - Fastener Specifications
Engine Front Splash Shield Retainer (2) - Install
Front Compartment Splash Shield Bolt (1) - Install and tighten [2x] - Fastener Specifications

Install the front tire and wheel assembly. Tire and Wheel Removal and Installation