Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Turn OFF the engine for 30 seconds before proceeding to purge the fuel pressure from the complete fuel system.
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Drain the water-in-fuel separator. Water-in-Fuel Draining
- Disconnect the electrical connector.
- NOTE:
Fuel pressure sensor is serviced as part of fuel feed hose assembly.
Fuel Pressure Sensor (1) - Disconnect [2x] - Plastic Collar Quick Connect Fitting Service
- Fuel Pressure Sensor (1) @Retainer (2) - Disengage [2x]
- Fuel Pressure Sensor (1) - Remove