Removal Procedure
- Set the parking brake in Service Mode. Parking Brake Service Mode Selection
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1/5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation (Steel Wheel) , or Tire and Wheel Removal and Installation (Aluminum Wheel)
{If equipped} Rear Brake Bleeder Valve Cap (1) - Remove
- {If equipped} Rear Disc Brake Pad Wear Sensor (2) @Rear Disc Brake Pad - Remove
Electrical Connector (1) @Rear Parking Brake Actuator - Disconnect
Rear Parking Brake Actuator Bolt (1) - Remove [2x]
Rear Parking Brake Actuator - (2) Remove
- Rear Parking Brake Actuator LeverSeal (1) - Remove and DISCARD
Rear Brake Hose Fitting (1) - Remove
- Rear Brake Washer (2) - Remove and DISCARD [2x]
- Rear Brake Hose (3) @Rear Brake Caliper - Remove
- Plug the rear brake hose fitting outlet to prevent brake fluid loss and contamination.
- Cap the rear brake caliper inlet to prevent brake fluid loss and contamination.
Rear Brake Caliper Guide Pin Bolt (2) - Remove [2x]
- Rear Brake Caliper (1) - Remove