Single Use Fasteners and Components
WARNING: This page is about a different variant/trim than selected.
- Automatic Transmission Case Front Cover Bolt
- Automatic Transmission Case Front Cover Seal
- Automatic Transmission Front Support Cover Gasket
Automatic Transmission Front Support Cover Gasket (1) - Install NEW
- Drive Sprocket Thrust Washer- Rear (2) - Install
- Drive Sprocket (3) - Install
- Drive Link (4) - Install
- Drive Sprocket Thrust Washer- Front (5) - Install
- Automatic Transmission Case Front Cover Seal (6) - Install NEW
- Ensure the drive link assembly is not pinched by the front cover and moves freely on the drive sprocket.
- Automatic Transmission Case Front Cover (7) - Install
- Automatic Transmission Case Front Cover Bolt (8) - Install NEW and tighten in sequence M6 x 30 [11x] 9.5 N.m (84 lb in)
CAUTION:
Refer to Fastener Caution .