LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 44 (Automatic Transmission - 8L45 - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Disassemble >> Single Use Fasteners and Components

Single Use Fasteners and Components

WARNING: This page is about a different variant/trim than selected.
  1. GM3681787Courtesy of GENERAL MOTORS COMPANY

    Disconnect the wiring harness connectors.

  2. Automatic Transmission Control Wiring Harness (1) - Remove
  3. Remove and DISCARD the wiring harness retainer (2), they are not reusable.
  4. GM5483676Courtesy of GENERAL MOTORS COMPANY

    Control Valve Channel Plate Bolt (1) - Remove [19x]

  5. Control Valve Channel Plate (2) - Remove
  6. CAUTION:

    Do not use the old spacer plate. Install a NEW spacer plate. Reusing an old spacer plate may cause internal transmission leaks and transmission damage.

  7. Control Valve Channel Plate Spacer Plate (3) - Remove and DISCARD
  8. GM5483677Courtesy of GENERAL MOTORS COMPANY

    Signal Accumulator Piston Spring (1) - Remove [7x]

  9. Signal Accumulator Piston (2) - Remove [7x]
  10. NOTE:

    Observe the position of the ball check valves.

  11. Cooler Flow Blowoff Ball Valve (3) - Remove [3x]
  12. GM5483678Courtesy of GENERAL MOTORS COMPANY

    Valve Body Bolt (1) - Remove [8x]

  13. Control Valve Solenoid Body (2) - Remove
  14. NOTE:

    Note the position of the ball check valve.

  15. Control Valve Body Ball Check Valve (3) - Remove
    • Without Surge Accumulator: [1x]
    • With Surge Accumulator: [3x]
  16. NOTE:

    Note the position of the ball check valve.

  17. Cooler Flow Blowoff Ball Valve (4) - Remove
  18. GM5483679Courtesy of GENERAL MOTORS COMPANY

    Control Valve Body Spacer Plate Retainer (1) - Remove and DISCARD [2x]

  19. CAUTION:

    Do not use the old spacer plate. Install a NEW spacer plate. Reusing an old spacer plate may cause internal transmission leaks and transmission damage.

  20. Control Valve Body Spacer Plate (2) - Remove and DISCARD
  21. NOTE:

    Note the position of the ball check valves.

  22. Cooler Flow Blowoff Ball Valve (3) - Remove [4 or 5x] - Model Dependent
  23. GM3681791Courtesy of GENERAL MOTORS COMPANY

    Automatic Transmission Fluid Pump Bolt (1) - Remove [5x]

  24. Automatic Transmission Fluid Pump (2) - Remove
  25. Automatic Transmission Fluid Pump Seal (3) - Remove and DISCARD
  26. Automatic Transmission Fluid Pump Seal (4) - Remove and DISCARD
  27. Automatic Transmission Fluid Pump Drive Shaft Bushing (5) - Remove
  28. Automatic Transmission Fluid Pump Passage Sleeve (6) - Remove
  29. NOTE:

    Only remove the locator pins if they need to be replaced.

  30. Automatic Transmission Fluid Pump Locating Pin (7) - Remove [2x]