Disassemble Procedure
WARNING: This page is about a different variant/trim than selected.
Turbine Shaft Retaining Ring (1) - Remove and DISCARD
- Turbine Shaft (2) - Remove
- Turbine Shaft Seal (3) - Remove and DISCARD
- Turbine Shaft Fluid Seal Ring (4) - Remove and DISCARD [4x]
- Turbine Shaft Fluid Seal Ring (5) - Remove and DISCARD [3x]
- Turbine Shaft Seal (6) - Remove and DISCARD
Using DT-38734 Intermediate Spring Compressor Adapter (1), and a press, remove and DISCARD the 1-3-5-6-7 clutch piston dam retaining ring (2).
- 1-3-5-6-7 Clutch Piston Dam (3) - Remove
- 1-3-5-6-7 Clutch Piston Return Spring (4) - Remove
1-3-5-6-7 Clutch Backing Plate Retaining Ring (1) - Remove
- 1-3-5-6-7 Clutch Backing Plate (2) - Remove
- 1-3-5-6-7 Clutch Plate - Friction (3) - Remove [5x]
- 1-3-5-6-7 Clutch Plate (4) - Remove [5x]
1-3-5-6-7 Clutch Piston (1) - Remove
- 1-3-5-6-7 Clutch Piston Dam Seal (2) - Remove and DISCARD
- 1-3-5-6-7 Clutch Piston Seal- Inner (3) - Remove and DISCARD
- 1-3-5-6-7 Clutch Piston Seal- Outer (4) - Remove and DISCARD
Using DT-26941 Bushing and Bearing Remover (1), and DT-45124 Removal Bridge (2), remove the 1-3-5-6-7 clutch thrust bearing (3).
CAUTION:
Refer to Seal Reuse Caution .