Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

1-2-7-8-Reverse Clutch Apply Ring (1) - Install
1-2-7-8-Reverse Clutch Return Spring (2) - Install
1-2-7-8-Reverse Clutch Piston (3) - Install
1-2-7-8-Reverse Clutch Piston Housing (4) - Install
The opening of the retaining ring should be in the position indicated by arrow.
Assemble the following tools:
- DT-35512 Bearing Installer (5)
- DT-48056 Spring Compressor Bridge (6)
- DT-50902 Adjustable Clutch Spring Compressor (7)
1-2-7-8-Reverse Clutch Piston Housing Retaining Ring (8) - Install